P02D7 BMW Fault Code
Check P02D7 OBD Fault Code ReasonVariable Cam Timing Over-advanced (Bank 1) The comprehensive component monitor (CCM) monitors the VCT position for an over-advanced camshaft timing.
The test fails when the camshaft timing exceeds a maximum calibrated value or remains in an advanced position.
BMW cam timing improperly set No oil flow to the VCT piston chamber Low oil pressure VCT solenoid valve stuck closed Camshaft advance mechanism binding (VCT unit) P02D7 DTC is a check of the VCT unit.
P02D7 Code Symptoms :
When you turn on the ignition, the Service Engine Soon or Check Engine P02D7 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the P02D7!
Diagnosis And Repairing P02D7
P02D7 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.
How to fix P02D7 code ?
- Erratic camshaft position due to low oil pressure
- Faulty ignition coil (s)
- Damaged camshaft position (CMP) sensor
- Open or short in the CMP sensor circuits
At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.
Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.
